Configure IP Addresses
NOTE: You are not required to configure all IP addresses at the same time
or to configure them in the order shown in this task.
- Choose Administration → Network.
-
Click Configure Active Settings to
make configuration changes in the Active network configuration profile.
NOTE: You can also click Configure Draft Settings or View Backup Settings to make configuration changes in the Draft or Backup network configuration profile, respectively.
- Click Edit.
-
Configure the management and secondary management IP addresses
on the Group tab in the Management IP
section.
- On the Primary row, enter the management IP address and subnet netmask. This IP address is used by the group leader array.
- (Optional) On the Secondary row, enter the secondary IP adddress, which is used by the backup group leader.
-
Configure the management and secondary management IP addresses on the
Subnet Configuration tab.
- On the Primary row, enter the management IP address and subnet netmask. This IP address is used by the group leader array.
- (Optional) On the Secondary row, enter the secondary IP adddress, which is used by the backup group leader.
-
Configure the data IP address when adding a subnet.
- Click the Subnets tab.
- Specify the parameters to create a new subnet.
- In the Assign Interfaces to this subnet section, click an available interface.
- In the Interface Assignment section, enter the data IP address in the Data IP Address field.
- Click Done.
-
Configure a data IP address when editing a subnet.
- On the Subnets tab, select a subnet that is carrying data trafic, and click Edit.
- In the Interface Assignment section, enter the data IP address in the Data IP Address field.
- Click Done.
-
Configure a data IP address when you configure an interface.
- Click the Interfaces tab.
- Select an interface assigned to a subnet carrying data traffic, and click Edit.
- Check the checkbox to select the interface that you want to configure.
- Click Configure.
- Select the Subnet from the dropdown menu if it is not already selected by default.
- If necessary, specify the data IP address for the subnet to which the interface is assigned.
- Click Done.
-
Configure the Support IP addresses.
- Click the Diagnostics tab.
- Specify the IP addresses for Controller A and Controller B.
-
Click Save.
The array OS validates the configuration, and commits the configuration if no error exists. If an error does exist, array OS returns an error message.