Configure a Static Route

You can onfigure one or more static routes.

  1. Choose Administration → Network.
  2. Click Configure Active Settings to configure IP addresses in the Active network configuration profile.
    NOTE: You can also click Configure Draft Settings or View Backup Settings to configure IP addresses in the Draft or Backup network configuration profile, respectively.
  3. Click Edit.
  4. On the Group tab, in the Routes section, click Add Route.
  5. Specify the IP address and netmask of a configured subnet.
    The route will run on the specified subnet.
  6. Specify the gateway IP address.
    NOTE: The gateway IP address must must be in the specified subnet.
  7. Click Save.
    The array OS validates the configuration change, and commits the configuration if no error exists. If an error does exist, the array OS returns an error message.