Configure VLAN Tagging
To enable VLAN tagging, first be sure a subnet has been created with a valid VLAN ID. (Subnets without a VLAN ID can only accept untagged traffic.) Then, assign network interfaces on an array to this subnet, and specify the interfaces as tagged. For more information on how to do this, see Configure a Subnet.
The procedure below describes how to configure an existing subnet from the Subnets tab. You can also perform the same subnet configuration from an interface-centric view using the Interfaces tab.
NOTE: Do not use the same network
for both back-end and front-end traffic. Heavy usage on one side will cause latency
or congestion issues on the other side, and there will be a cascading impact to the
overall environment.