Configure a Subnet
You can configure one or more subnets.
Procedure
- Choose .
-
Click Configure Active Settings to
make configuration changes in the Active network configuration profile.
Note: You can also click Configure Draft Settings or View Backup Settings to make configuration changes in the Draft or Backup network configuration profile, respectively.
- Click Edit, then click the Subnets tab.
-
Do one of the following:
- Click Add to configure a new subnet.
- Check the checkbox nest to an existing subnet and click Edit to change its settings.
-
Configure the subnet settings.
Note: If you choose the Custom frame size, you must specify the size in the Bytes field.
If you want to specify a VLAN ID, you can find more information in Configure VLAN Tagging.
- Click an available interface to assign to the subnet, specify the data IP address (if required), then click Done.
- (Optional) Repeat the steps to configure more subnets.
- Click Done. NimbleOS validates the configuration change and commits the configuration if no error exists. If an error does exist, NimbleOS returns an error message.